Mounting; Mounting On A Support Rail - HBM ClipX Bedienungsanleitung

5

Mounting

The ClipX is designed for mounting on a support rail (35 mm DIN rail to DIN
EN 60715). You can choose different mounting methods if you want though. The
support rail on which you mount the ClipX may be 8.5 or 16 mm deep.
Important: You must ground the support rail.
5.1

Mounting on a support rail

Fig. 3: Mounting on a support rail
1. Hang the ClipX from the top edge of the support rail.
2. Push the ClipX onto the support rail in the direction of the arrow as shown in
the picture.
The clip at the bottom secures the ClipX by a spring.
ClipX
A04643_04_X00_03 HBM: public
Mounting
17