HBM ClipX Bedienungsanleitung Seite 132

Operation via fieldbus
Designa-
tion
Captured
value 1
Captured
value 2
ClipX bus
value 1 ... 6
Calculated
value 1 ... 6
Limit value 1
... 4
External Eth.
value 1
External Eth.
value 2
Analog out-
put
I/O-Status
low
I/O status
high
Measured
value status
Control word
Parameter
set number
130
Cycle in
Format
ms
FLOAT 1
FLOAT 1
FLOAT 1
Event-
FLOAT
controlled
FLOAT 1
0.52 ...
FLOAT
1)
1
UDINT
1
UDINT
UDINT
0.52...1
UDINT 1
Event-
UINT
controlled
A04643_04_X00_03 HBM: public
Explanation
Captured value 1.
Captured value 2.
Value on the device's ClipX bus with address
1 ... 6.
Value of calculation channel 1 ... 6.
Value of the respective limit value 1 ... 4.
Value 1 transmitted via Ethernet.
Value 2 transmitted via Ethernet.
Value of the analog output in V or mA.
See "Digital flags: List of I/O flags (I/O sta-
tus)" on page
See "Measured value status: List of status
1)
bits" on page
The echo of the control word – see section
headed "Data transfer from the controller to
the ClipX" on page
has been triggered when the received con-
trol word is equal to the one sent.
The number of the active parameter set.
162.
157.
126. The desired function
ClipX