Digital Flags: List Of I/O Flags (I/O Status) - HBM ClipX Bedienungsanleitung

Operation via fieldbus
Status
Configuration failed
Read error
Error checksum
No data
9.6.4

Digital flags: List of I/O flags (I/O status)

The table below sets out the bits in the I/O status (64 bits). The bit is set if the
relevant status is active.
Bit Explanation
0 Digital input 1.
1 Digital input 2.
2 Digital input 1 debounced.
3 Digital input 2 debounced.
4 Digital output 1.
5 Digital output 2.
6 Digital output 1 delayed.
7 Digital output 2 delayed.
8 Result for limit value switch 1.
162
Bit
6 The settings in the TEDS module could not be
made. Check the settings in the TEDS module. It
might be that a sensor type or scaling is specified
which the ClipX does not support (requires different
hardware).
7 The TEDS module could not be read.
8 The information in the TEDS module contains errors
and cannot be evaluated. Try to save the TEDS
information to the module again (requires different
hardware; the ClipX cannot write to a TEDS mod-
ule).
9 The TEDS module does not contain any data; the
first 256 bytes are 0 or 255 (new unwritten module).
A04643_04_X00_03 HBM: public
Explanation
I/O status
Low word
ClipX