Connecting The Supply Voltage - HBM ClipX Bedienungsanleitung

6.5

Connecting the supply voltage

Connect the supply voltage from 10 to 30 V
See also "Available connections and LEDs" on page
Note
Voltages above 30 V
Make sure that the supply voltage is between 10 and 30 V
Fig. 10: Supply voltage at plug terminal X2
For each ClipX you must provide a power output of 5 W plus the power required
for analog and digital outputs. Use an appropriately dimensioned cable for the
supply voltage to avoid an excessive voltage drop when operating multiple
devices. We recommend using wire end ferrules and a cable cross-section of
2
1.5 mm (AWG16).
ClipX
can destroy the ClipX.
DC
Housing
ClipX bus
CxA
X
ClipX bus GND
CxB ClipX bus
Sync Synchronization
DI Digital In GND
DI2 Digital In 2
Digital In 1
DI1
DO2 Digital Out 2
DO1 Digital Out 1
Supply 0 V
0V
24V Supply 10 ... 30 V
A04643_04_X00_03 HBM: public
Electrical connections, LEDs
to terminal X2 (top).
DC
24.
.
DC
35