Strain Gage Full And Half Bridge, Voltage-Fed Piezo-Resistive - HBM ClipX Bedienungsanleitung

6.6.1 Strain gage full and half bridge, voltage-fed piezo-resistive sensors
When connecting transducers in a 6-wire configuration, you can also use Zero-
Wire TEDS instead of the 1-Wire TEDS connection. In this case the TEDS mod-
ule is looped into the sense lines.
See also "Available connections and LEDs" on page
ing design" on page
Important: When connecting cable lengths > 50 m, you must connect
the sense leads to the ClipX using one resistor each with half the
value of the bridge resistance (1/2 R
ClipX
23.
A04643_04_X00_03 HBM: public
Electrical connections, LEDs
24, "Shielding and ground-
).
B
37