System Status: List Of Status Bits - HBM ClipX Bedienungsanleitung

Designation
Calculated value 6
External Eth. value 1
External Eth. value 2
External FB value 1
External FB value 2
Analog output
9.6.2

System status: List of status bits

The following table sets out the bits in the system status (32 bits) if the status in
question is set.
Status/error
Device ready
Sync master
Sync slave
Sync slave no sync-
in
Changing parame-
ter set
Error parameter set
ClipX
Explanatory note for bit set i.e. value is
Bit
invalid
26 Value of calculated channel 6.
27 Value 1 transmitted via Ethernet.
28 Value 2 transmitted via Ethernet.
29 Value 1 transmitted via the fieldbus.
30 Value 2 transmitted via the fieldbus.
31 Value of the analog output in V or mA.
Bit Explanation for bit set
0 The ClipX is switched on, initialized, and the Ether-
net connection is live.
1 The device is configured as the master for CF syn-
chronization.
2 The device is configured as a slave for CF synchro-
nization.
3 The device is configured as a slave for CF synchro-
nization but no signal is connected.
4 The active parameter set is being switched.
5 Error in the current loaded parameter set. Load a dif-
ferent parameter set or check all settings and resave
the parameter set. If the parameter set is stored on
PC, you can also import it from there and check the
stored version for errors.
A04643_04_X00_03 HBM: public
Operation via fieldbus
159