HBM ClipX Bedienungsanleitung Seite 162

Operation via fieldbus
Status/error
Error file system
Error ADC communi-
cation
Error ADC IRQ
Error ADC stuck (no
change for more
than 50 ms)
Error ADC DMA
Error DAC communi-
cation
DAC alarm
Error 1-Wire commu-
nication
Error ClipX bus
Error external RAM
Error sensor exci-
tation
Fieldbus I/O
Error fieldbus con-
troller
Error factory calibra-
tion
160
Bit Explanation for bit set
6 Internal error in the device. Make a note of the error
type and contact HBM
7
235.
8
9
10
11
12 No current can flow at the current output; there is a
line break.
13 The 1-Wire TEDS cannot be read. Check the wiring.
If possible, check whether the TEDS module can be
read on another device, or is defective.
14 The ClipX bus is not working correctly. Check the
wiring of the bus system.
15 Error in the RAM of the ClipX (not in the RAM of the
CPU). Make a note of the error type and contact
HBM "Technical support" on page
16 The excitation voltage for the sensor has been short-
circuited. Check the wiring of the sensor.
17 Cyclic communication is taking place on the fieldbus
(only BM40IE and BM40PB).
18 Internal error in the fieldbus controller (only on
BM40IE and BM40PB). Make a note of the error
type and contact HBM
235.
19 There is an error in the calibration of the ClipX. Make
a note of the error type and contact HBM
support" on page
A04643_04_X00_03 HBM: public
"Technical support" on page
235.
"Technical support" on page
235.
"Technical
ClipX