HBM ClipX Bedienungsanleitung Seite 75

c) Connect your PC and the ClipX by an Ethernet cable. In very rare cases,
you will need an Ethernet cross cable for this. Normally the PC will adapt
automatically to the cable.
Important: The transfer of commands and data is not encrypted or
secure (no https). So you should only operate the ClipX in an internal
network with no connection to the Internet or – if an Internet connec-
tion is essential – connect via a VPN tunnel.
If you want to use multiple ClipX devices, first connector to each individ-
ual ClipX and assign a unique device name (or a fixed IP address)
through your web browser. This will enable you to identify the individual
ClipX devices later, otherwise (depending on the connection method you
use) it will not always be possible to distinguish between them.
Connecting
1. Launch your web browser.
The latest versions of Firefox, Chrome and Microsoft Internet Explorer (ver-
sion 11 or higher) are supported and have been tested by HBM.
2. Enter ClipX/ or http://ClipX/ or http://ClipX.local in the address bar. Enter
192.168.0.234 if you are using the fixed (static) IP address of the ClipX –
see "Resetting Ethernet network settings (DHCP), enabling fixed IP
address" on page
3. The start screen (Login) with User Management is displayed. From it,
select your user level or the Home menu.
Important: Do not use https; only http.
If you have already changed the device name, you must enter the new name in
place of ClipX. If you have forgotten the name, try one of the alternative options
for example.
ClipX
80.
A04643_04_X00_03 HBM: public
Starting up the ClipX
73