How Do You Access The Clipx Objects - HBM ClipX Bedienungsanleitung

Operation via fieldbus
Term Explanation
Type Data type, see also
Access W: Write
R: Read
RO: Read only
WO: Write only
S: Changing possible by changing parameter set
Y: Cyclic change.
The following tables list only RO and WO. Commands with no speci-
fication are RW.
Tips
For the dynamic calculation objects the best sequence of generating them is:
1. Set up the calculated channels via the web interface or write the desired
block types to objects 0x5001.1 ... 6.
2. Generate the object list as described above. This list then contains all the
required dynamic objects.
3. Edit the objects using your PC-based or PLC program.
If you are uncertain about any setting, use your web browser to make it. Then
read out the value via the relevant object in the object dictionary.
9.7.1

How do you access the ClipX objects?

See also "Data transfer from the controller to the ClipX" on page
transfer from the ClipX to the controller" on page 129
access via the fieldbus" on page
To address the objects use container objects in the cyclic data.
166
"Data types used by the ClipX" on page
170.
A04643_04_X00_03 HBM: public
125.
126,
and "Examples of object
"Data
ClipX