Use Teds - HBM ClipX Bedienungsanleitung

6.7

Use TEDS

When the ClipX is powered up, or a sensor is connected, the information in the
TEDS module is read and the ClipX is set accordingly (sensor type, scaling,
bridge excitation voltage, etc.).
You can use transducers with both 1-Wire and Zero-Wire TEDS (TEDS module
in the sense lines). If both TEDS connection variants are installed in the trans-
ducer, only the 1-Wire module is used.
The TEDS symbol displayed in the browser does not mean that only
the information from the TEDS module is used. It indicates that a
TEDS module is present in the sensor. However, the settings made
when connecting the sensor or switching on the ClipX based on the
information in the TEDS can be overwritten afterwards via the
browser or the field buses.
Specifying usage
You can choose between three TEDS usage variants via your browser's TEDS
menu:
1. Ignore TEDS.
2. Use TEDS, if installed.
3. TEDS required.
In the third variant, an error is signaled if no TEDS is found, or cannot be set as
specified.
Supported templates (Information)
• Strain gage (template: Strain Gage)
• Full or half bridge sensor (template: Bridge Sensor)
• Voltage (setting Volt, template: High Level Voltage Output Sensor)
• Sensor with current output (settings Current, template: Current Loop Output
Sensor)
• Potentiometer (template: Potentiometric Voltage Divider)
ClipX
A04643_04_X00_03 HBM: public
Electrical connections, LEDs
51