HBM ClipX Bedienungsanleitung Seite 97

Start by digital signals
Signal at
Input
0
1
0
1
0
1
0
1, 2
Fig. 44: Automatic mean; Start via digital signals
Specify a digital signal (digital input, limit switch or flag) for the Start Measure
with and Start Zeroing with conditions. As soon as a channel is entered here,
any specified limit value is ignored for the condition in question. The inputs are
triggered by an edge from Low (0) to High (1). A constant value deactivates the
input.
Status
Value Explanation
1, 2 Wait for start of measurement or limit value overshoot.
3 Wait for the end of the delay measurement.
4 Status during measuring time. When the measurement is complete, the
maximum, minimum, peak-to-peak and mean values are updated.
ClipX
3 4
Meas. Meas.
Delay Time
Update of Maximum Value,
Minimum Value, Peak-to-Peak
and Mean
A04643_04_X00_03 HBM: public
5 6
Zero Tracking
Delay
Starting up the ClipX
Measured Value
7 1, 2
Zero
Tracking
Time
Update Offset
t
Start Measure
Start Zeroing
Ready Flag
Status
95