6.10 Using Multiple Clipx Devices, Clipx Bus - HBM ClipX Bedienungsanleitung

6.10 Using multiple ClipX devices, ClipX bus

You can transfer one measured value with status from each of up to five other
ClipX devices over the ClipX bus to a ClipX and then capture them simultane-
ously with the values of that device. The connections use line topology. The
maximum cable length between two devices is 30 cm.
Interconnect the CxA terminals and CxB terminals respectively of up to six
devices. Lay the lines from the first device to the second, from the second to the
third device, etc. (line topology). The ClipX bus GND connection is additionally
required. The CxA and CxB lines must be twisted and shielded.
See also "Available connections and LEDs" on page
ClipX CF amplifiers" on page
max. 30 cm
SYS
BM 40
Fig. 27: Transferring a measured value from multiple ClipX devices
The ClipX bus synchronizes automatically. All you have to do is enter the High-
est Address (number of devices) and the Own Address (location where the
ClipX
59.
SYS
BUS
40
BM PB
PROFIBUS
A04643_04_X00_03 HBM: public
Electrical connections, LEDs
24,
SYS
RUN SF MS
ERR BF NS
40
BM IE
P1 IN
P2 OUT
"Synchronizing multiple
SYS
BM 40
57