HBM ClipX Bedienungsanleitung Seite 160

Operation via fieldbus
You can change some of the (default) signal names, e.g. ClipX bus
value 1 to Pressing force. This means your names might differ from
the ones in the table.
Designation
Electrical value (field
value)
Gross
Net
Minimum
Maximum
Peak-to-peak
Captured value 1
Captured value 2
ClipX bus value 1
ClipX bus value 2
ClipX bus value 3
ClipX bus value 4
ClipX bus value 5
ClipX bus value 6
Calculated value 1
Calculated value 2
Calculated value 3
Calculated value 4
Calculated value 5
158
Explanatory note for bit set i.e. value is
Bit
invalid
Input signal in the unit of the measured quantity, e.g.
2
in mV/V.
3 Gross signal.
4 Net signal.
5 Peak value minimum.
6 Peak value maximum.
7 Peak value peak-to-peak.
8 Captured value 1.
9 Captured value 2.
10 Value on ClipX bus from the device with address 1.
11 Value on ClipX bus from the device with address 2.
12 Value on ClipX bus from the device with address 3.
13 Value on ClipX bus from the device with address 4.
14 Value on ClipX bus from the device with address 5.
15 Value on ClipX bus from the device with address 6.
21 Value of calculated channel 1.
22 Value of calculated channel 2.
23 Value of calculated channel 3.
24 Value of calculated channel 4.
25 Value of calculated channel 5.
A04643_04_X00_03 HBM: public
ClipX