Ethernet Interface; Digital Input, Digital Outputs - HBM CMD Serie Bedienungsanleitung

CMD
7.4

Ethernet interface

This interface can be used to integrate the CMD into a
controller or connect it to a PC for parameterization. The
interface also permits measured values to be sent to a
host processor - via UDP streaming.
Parameterize the CMD with the CMD Assistant software
on the CD, or use a command set via a terminal (see
Section 9.2).
The CD also contains drivers and a library for Lab­
VIEWt, so that you can integrate the CMD into this
National Instruments software.
There is also a PLC example on the CD, showing how
the CMD can be connected to a Siemens S7 controller
and operated via TCP/IP.
Tip
The latest CMD Assistant and all the software can be
found at http://www.hbm.com/support
7.5

Digital input, digital outputs

The following functions are available for the digital input
and the digital outputs:
A2781-3.1 HBM: public
Device description
23