Data Transfer From The Controller To The Clipx - HBM ClipX Bedienungsanleitung

Operation via fieldbus
Abbreviation
DINT
USINT
UINT
UDINT
STRING
9.3

Data transfer from the controller to the ClipX

See also "Data types used by the ClipX" on page
The following table sets out the data and the speed at which the data are down-
loaded by the ClipX in the event of a change. The speed (cycle in ms) is not syn-
chronized with the fieldbus, or with PROFINET IRT or EtherCAT Distributed
Clocks. The inputs and outputs of the ClipX are processed out of sync with the
fieldbus. The synchronous modes of the ClipX with these fieldbus systems pro-
vide only synchronized data transfer, not processing of the data. The processing
of queries and commands, such as the control word or access to the object dic-
tionary, normally takes additional time. In case of doubt, perform your own time
measurements with your system – see also
ClipX and over the ClipX bus" on page
126
Description
32 bits, integer signed
8 bits, integer unsigned
16 bits, integer unsigned
32 bits, integer unsigned
Text
61.
A04643_04_X00_03 HBM: public
125.
"Signal phase delays within the
ClipX