No Device Found - HBM ClipX Bedienungsanleitung

https://play.google.com/store/apps/details?id=com.tjjang.upnptool
https://play.google.com/store/apps/details?id=com.melloware.zeroconf
The apps use different connection methods – see also
below.
Linux
Under Linux you can also type one of the following lines to call up a list of ClipX
devices and their IP addresses or MAC addresses respectively and enter them
in your browser:
$ nmblookup clipx
$ avahi-browse --all
Which line works is dependent on which method (NetBIOS or Bonjour) you are
able to use, i.e. what software is installed on your PC.
7.2.1

No device found?

If no connection is made, there may be a number of reasons.
General reasons
•
Is the device actually on (connected to the power supply)?
•
Is the system LED on the ClipX lit? See also
page 26.
•
Is the interface cable connected?
•
Have you enabled the correct interface or correct interface adapter on the
PC?
Problems with the interface
•
Are you using the correct Ethernet cable?
Use an Ethernet switch with a standard cable or a direct connection by a
cross cable.
•
Is your Ethernet switch operating correctly?
ClipX
A04643_04_X00_03 HBM: public
Starting up the ClipX
"No device found?"
"Health-Monitoring, LEDs" on
75