HBM ClipX Bedienungsanleitung Seite 114

Operation via Ethernet/OPC UA
Example 1: Reading a gross measurement value
Function
Command
Response
1)
You can also use CRLF in place of LF
The gross measurement value is 1500,496.
Example 2: Polling measurement status
Function
Command
Response
1)
You can also use CRLF in place of LF
You must interpret the return value bit-wise. Starting from bit 0, bit 3 is the status
for the gross measurement value (value in the
page 222 +1). In this example, the gross measurement value is valid, as are the
peak values and captured values. The values on the ClipX bus are invalid (0:
valid; 1: invalid).
Example 3: Zero balancing (zeroing)
Function
Command
Response
1)
You can also use CRLF in place of LF
The command was executed without error.
You must specify the last parameter (value 0) in order to maintain the
SDO syntax. The parameter is ignored by the ClipX.
112
Command/response
SDO? 0x44f0,4LF
1500.496CRLF
Command/response
SDO? 0x44f4,1LF
2095104CRLF
Command/response
SDO 0x4410,4,0LF
0CRLF
A04643_04_X00_03 HBM: public
1)
1)
"List of signal references" on
1)
ClipX