HBM ClipX Bedienungsanleitung Seite 182

Operation via fieldbus
Subin-
Index
dex
0x4D00 3
0x4D00 4
0x4D00 11
0x4D00 12
0x4D00 21
0x4D00 22
0x4D00 25
0x4D00 26
FIFO (for up to six signal sources)
See also "Operation and content of the ClipX-FIFO" on page
nels with 1000 values (4000 from firmware 2.0) each are available for storing
measured values. The oldest values are overwritten when all memory locations
are occupied. At the same time the overflow bit is set (FIFO control flags).
180
Function
Switch OPC UA on or off.
The value is stored.
Command to start or stop
OPC UA, the value is not
stored.
After restarting the device,
0x4D00.3 is decisive.
Status (Usage) of session 1.
Status (Usage) of session 2.
Subscription status of ses-
sion 1.
Subscription status of ses-
sion 2.
Publishing interval in ms for
the subscription of session
1.
Publishing interval in ms for
the subscription of session
2.
A04643_04_X00_03 HBM: public
Value
0: OPC UA off
1: OPC UA on
1: Start
2: Stop
3: Restart
1: Unused
2: Created, not active
4: Active.
0: Passive
1, 2: Active, ok
3: Active, late (the transfer is
overdue)
0 if passive.
113. 6 FIFO chan-
ClipX