HBM ClipX Bedienungsanleitung Seite 83

Fig. 36: System LED (1) and Reset button (2)
Resetting the Ethernet settings to their factory defaults (DHCP)
1. Switch off the power supply.
2. Press the Reset button (see picture) using a pencil or a small screwdriver
and keep it pressed while you switch the power back on.
3. Wait for the system LED to start flickering green before releasing the button.
The ClipX then reboots.
4. Wait for the reboot to complete before connecting to the device.
Ethernet port settings afterwards (factory defaults)
• Use DHCP ("Obtain an IP address automatically", meaning from the server
or via APIPA, i.e. negotiate in the network, if your PC is also using DHCP).
• Device name: ClipX.
• All manual IP address, subnet mask, gateway or DNS settings are cleared.
Enabling fixed ClipX Ethernet address 192.168.0.234 (from firmware 2.0)
1. Switch on the supply voltage.
2. Wait about one minute until the device is ready.
3. Press the Reset button (see illustration) three times using a pen or small
screwdriver. Each press must be held for at least 0.5 seconds, and the
pause between them must not be more than 3 seconds.
ClipX
A04643_04_X00_03 HBM: public
Starting up the ClipX
81