HBM ClipX Bedienungsanleitung Seite 29

System LED (SYS)
SYS-
Status
LED
Off
Off
On
Green
On
Yellow
/
Flashing
Red/
green
ClipX
Meaning
No supply voltage, or ClipX defective.
The ClipX has fully booted up, and is ready.
Error on ClipX bus:
– One or more of the expected devices is not transmitting,
or not responding
– Errors in data transfer
If an invalid external measurement value is correctly trans-
mitted, it does NOT result in a yellow or red system LED. It
causes an invalid status of the external measurement value
in question (one bit per value).
Manual device detection (via the browser) has been started.
or
The ClipX is not ready.
or
None of the other meanings in this table applies. If this state
lasts longer than a few seconds, please contact HBM
nical support" on page
Note that the red/green flash can also be triggered via your
browser to identify a device (Home menu, click on
A04643_04_X00_03 HBM: public
Electrical connections, LEDs
235.
"Tech-
).
27