Operation And Content Of The Clipx-Fifo - HBM ClipX Bedienungsanleitung

Example 4: Setting sensor type ±10 V
Function
Command
Response
1)
You can also use CRLF in place of LF
The command was executed without error.
Example 5: Setting the filter cut-off frequency to 0.5 Hz
Function
Command
Response
1)
You can also use CRLF in place of LF
The command was executed without error.
8.2

Operation and content of the ClipX-FIFO

Use the ClipX-FIFO to record measurement values over a period of time or
during an interesting process step. The control system can then read out the
values via the Ethernet interface or one of the fieldbuses. You can have the
recording performed continuously on a start signal or control it via various trig-
ger conditions. Up to 1000 measured values (4000 from firmware 2.0) each
from 6 different signal sources (gross, net, ClipX bus, etc.) are recorded. The
oldest values are overwritten when all memory locations are occupied. At the
same time the overflow bit is set (FIFO control flags). The maximum recording
speed is 1000 values per second. You can also have recorded a value from all
signal sources every 10 seconds (recording rate 0.1/s) or if the source signal
changes by a certain amount.
ClipX
Command/response
SDO 0x4400,1,0LF
0CRLF
Command/response
SDO 0x4401,2,0.5LF
0CRLF
A04643_04_X00_03 HBM: public
Operation via Ethernet/OPC UA
1)
1)
113