Object Dictionary - HBM ClipX Bedienungsanleitung

Operation via fieldbus
Bit
3 Clear Tare Value (= 0).
4 Set the 1st point electrically in two-point scaling.
5 Set the 2nd point electrically of two-point scaling.
6 Hold Captured value 1.
7 Hold Captured value 2.
8 Delete Captured value 1.
9 Delete Captured value 2.
10 Reset Limit Switch 1.
11 Reset Limit Switch 2.
12 Reset Limit Switch 3.
13 Reset Limit Switch 4.
14 Reset maximum, minimum and peak-to-peak value.
15 Hold maximum, minimum and peak-to-peak value (as long as this bit is set).
16 Filter fast-track. The filter output jumps to the input value.
Save current settings to current parameter set (corresponds to the
17
button in the Parameter Sets menu).
9.7

Object dictionary

For most applications, the cyclic data that can be transmitted over the respec-
tive fieldbus are sufficient. For special applications, the object dictionary is avail-
able. You can use it to access all the settings of a ClipX. You can use the object
directory with the fieldbuses or via Ethernet or with OPC UA.
See also "Data transfer from the controller to the ClipX" on page
transfer from the ClipX to the controller" on page
net/OPC UA" on page
FIBUS" on page 134
164
109. You will find DPV1 objects in the
section.
A04643_04_X00_03 HBM: public
Function
129, "Operation via Ether-
SAVE
126, "Data
"Settings for PRO-
ClipX