Settings For Profibus - HBM ClipX Bedienungsanleitung

Operation via fieldbus
– No server in network: Set STATIC under Config Control and specify IP
Address and Netmask (subnet mask). The Gateway setting is optional,
and depends on your network.
Click on APPLY
Then select which cyclic I/O data you want to transmit, as no configuration
object exists. Click
ning EtherNet/IP™ connection is closed and is restarted with the changed I/O
image. At the top of the browser window you see the current settings. Import
them manually into your EtherNet/IP™ configuration tool.
You can also download your configuration to your PC as a CSV file for docu-
mentation purposes
ting, you are prompted to select a folder, or the file is saved to your Download
folder. The file is for information purposes only, however, and cannot be reim-
ported.
From the menu choose Device Storage and
appropriate to save the configuration on your PC and transfer it to
another device.
9.5.4

Settings for PROFIBUS

In your browser, specify the address of the ClipX on the PROFIBUS. The fac-
tory setting is 126 (invalid address). The bit rate is automatically detected by the
ClipX. Carry out the further configuration of the fieldbus using your PROFIBUS
configuration tool.
After configuring the ClipX, you can download the resultant GSD file and the
DPV1 list to the PC:
ing on your browser setting, you are prompted to select a folder, or the file is
saved to your Download folder.
The names you set for the various signals are applied in the GSD file.
The minimum cycle time (Min_Slave_Intervall) is 0.6 ms. If the PRO-
FIBUS controller does not take this value from the GSD file, you must
set it manually.
134
to apply the settings.
APPLY to apply your configuration. When you do so, a run-
(DOWNLOAD
DOWNLOAD GSD
A04643_04_X00_03 HBM: public
IO-IMAGE). Depending on your browser set-
and DOWNLOAD DPV1
BACKUP or RESTORE
LIST. Depend-
as
ClipX