HBM ClipX Bedienungsanleitung Seite 234

Diagnostics and error rectification, FAQs
Do I have to install operating software?
No. The ClipX has an internal web server for parameterization. All you need is a
browser, such as Windows Internet Explorer (min. version 9), Firefox or Google
Chrome.
What do I do if I have forgotten the password?
You can temporarily disable user management by pressing and holding down
the Reset button on the front of the ClipX while logging in or changing a pass-
word (any password is accepted, including a blank password field). You will nor-
mally need a second colleague to press the button while you are logging in.
See also "Available connections and LEDs" on page
What must I watch out for when connecting the ClipX to a PC?
An Ethernet cable must be plugged in. Both ends must be set to DHCP (ClipX
factory default setting: DHCP). Connect to the ClipX by typing
browser's address bar.
How can I synchronize multiple ClipX devices?
By interconnecting the SYNC outputs (and ClipX bus GND).
The ClipX devices synchronize automatically. You can interconnect a maximum
of six ClipX devices. The maximum cable length between two devices is 30 cm.
The A/D converters are only synchronized when carrier frequency (CF) measur-
ing amplifiers are being synchronized.
See also "Synchronizing multiple ClipX CF amplifiers" on page
ple ClipX devices, ClipX bus" on page
What is the purpose of the ClipX bus?
You can interconnect up to six devices over the ClipX bus. Each device can
transmit a signal on the bus, so up to five signals from other ClipX devices are
available on each device. The measured values are transferred automatically.
All you have to do is specify on each device which signal is to be transferred,
and at which address.
See also "Using multiple ClipX devices, ClipX bus" on page
232
57.
A04643_04_X00_03 HBM: public
24.
ClipX/
59, "Using multi-
57.
in your
ClipX