HBM ClipX Bedienungsanleitung Seite 42

Electrical connections, LEDs
Strain gage full or half bridge and piezo-resistive sensors in 6-wire config-
uration with Zero-Wire TEDS, version for D-sub-HD15
The solder terminals on this TEDS module are not labeled. On the side with the
four contact surfaces (in the diagram on the upper side of the module) you must
connect the sensor leads. The contacts represented with dashed lines are on
the bottom of the TEDS module. Connect the + and - sense leads there.
Pt100
TEDS
4
1
2'
2
3'
3
I
U
Fig. 14: Plug terminal X4, pin assignment in 6-wire configuration with Zero-Wire
TEDS, version for D-sub-HD15; with half bridge, connector 4 is omitted
40
S
Inner cable shield
Measurement signal −
Measurement signal +
Sense lead −
Bridge excitation voltage −
Sense lead +
Bridge excitation voltage +
Outer cable shield
AI
A04643_04_X00_03 HBM: public
Zero-Wire-TEDS
Cable wire colors (HBM transducer):
bu = blue; gn = green; gy = gray;
rd = red; bk = black; wh = white;
rd
wh
2
bk
gy
1
bu
gn
3
ClipX
4