Limit Switches - HBM ClipX Bedienungsanleitung

Operation via fieldbus
Subin-
Index
dex
0x4038 1 (2)
0x4039 1 (2)
0x403A 1 (2)
0x403B 1 (2)

Limit switches

Subin-
Index
dex
0x4600 1
0x4601 1 ... 4
0x4602 1
0x4603 1 ... 4
0x4604 1 ... 4
0x4605 1 ... 4
0x4606 1 ... 4
0x4607 1 ... 4
218
Function
Clear by inverting.
Select signal source.
"Delete" command.
"Hold" command.
Function
Bit-wise status of all limit
switches.
Status of a single limit
switch.
Clear one or more limit
switches (from hysteresis) if
corresponding bit is set.
Clear a single limit switch.
Limit value.
Value of hysteresis or range
(band mode).
Select signal source.
Mode.
A04643_04_X00_03 HBM: public
Value
0: Not inverted
1: Inverted, UINT8.
0 ... 31, see "List of signal ref-
erences" on page
WO.
WO.
Value
0 ... 15, only lowest 4 bits,
UINT8, RO.
0: Not triggered
1: Triggered, UINT8, RO.
0 ... 15, only lowest 4 bits;
Clear if bit = 1, UINT8, WO.
0: No action
1: Clear, UINT8, WO.
FLOAT.
0 ... 31, see "List of signal ref-
erences" on page
1: Above level
2: Below level
3: In band
4: Outside band, UINT8.
222, UINT8.
222, UINT8.
ClipX