Using Parameter Sets - HBM ClipX Bedienungsanleitung

Starting up the ClipX
0.0
Output
Input
AND
Time
Flag
Standstill detection
Amplitude
Standstill
Threshold High
Flag
Near zero detection
Threshold Low
Near Zero
Fig. 49: Principle of operation of standstill detection and near-zero detection
If the source signal is invalid, no further values are calculated. All output values
are frozen (remain unchanged). As soon as the source signal is valid again, new
values are calculated.
7.5

Using parameter sets

You can store up to 10 parameter sets in the ClipX. A parameter set contains
almost all the settings of the various menus for Amplifiers (sensors), Calcu-
lated Channels, Peak Values and Limit Switches etc. It does not include the
network settings, TEDS usage, the passwords, the visualization, fieldbus and
ClipX bus settings and settings for synchronization of the CF amplifiers.
You can also transfer the parameter sets together with the other device settings
to your PC. Give the parameter sets names so that you can distinguish them
more easily. You can use up to 30 characters per name.
The active parameter set is indicated by ACTIVE, and the start parameter
set by BOOT.
104 ClipX
A04643_04_X00_03 HBM: public