Starting Up The Clipx; Power-Up And Operating Behavior - HBM ClipX Bedienungsanleitung

7

Starting up the ClipX

The first section of this chapter explains the general power-up and operating
behavior of the ClipX following a successful installation. Then the steps required
to put the ClipX into operation are explained. For initial start-up, you should con-
nect the ClipX via Ethernet to a PC. The description of operation via one of the
fieldbuses can be found in chapter
If you want to operate multiple ClipX devices, you should first connect
each ClipX device individually to a PC and perform a basic configu-
ration (e.g. IP address and Name).
Then read the section headed
amplifiers" on page 59
devices.
7.1

Power-up and operating behavior

When the ClipX is powered up, all the inputs and output remain at 0 or 0.0 V as
appropriate. The start parameter set is loaded and activated first (= initializa-
tion). As soon as the ClipX has initialized, the outputs are set to the preset or
calculated values (factory setting for the digital outputs: 0, not inverted). If the
analog output is inactive, the output has a high internal resistance. If the source
signal for the analog output is invalid, the specified value in case of an invalid
signal is outputted (factory setting 11 V but disabled).
The digital inputs and outputs and the calculations are updated at1000 Hz. The
signal at the analog output is updated at 19.2 kHz. If the source signal has a
smaller rate of change, the value is outputted multiple times. Values are trans-
ferred from synchronized ClipX devices at a maximum of 1000 values per sec-
ond, so with six connected device you get 6000 values per second. The maxi-
mum time delay between the ClipX values transmitted over the ClipX bus is
1 ms.
ClipX
"Operation via fieldbus" on page
"Synchronizing multiple ClipX CF
so as to avoid interference between the
A04643_04_X00_03 HBM: public
Starting up the ClipX
123.
71