Connecting A Web Browser To The Clipx - HBM ClipX Bedienungsanleitung

Starting up the ClipX
Up to three clients (PCs) can connect to a ClipX; any further connec-
tion is then rejected.
Important: Some browsers make more than one connection. In this
case, the number of possible additional connections is reduced.
See also
7.2

Connecting a web browser to the ClipX

Preparing to connect
You have two options for connecting to the ClipX:
1. You are using the ClipX's default settings (DHCP, automatic address assign-
ment)
a) Make sure that your PC is also using DHCP (Get IP address automati-
cally) – see also
b) Connect your PC either directly to the ClipX or connect your PC and the
ClipX to your network or switch.
c) After connecting, wait about one minute for the ClipX and PC to set their
addresses before connecting.
2. You are using the ClipX's fixed IP address (192.168.0.234, from firmware
2.0)
a) Enable the ClipX's fixed address as described in the section headed
"Resetting Ethernet network settings (DHCP), enabling fixed IP
address" on page
b) Make sure that your PC's IP address is in the same network segment
(192.168.0.x, where x is a number between 1 and 254 other than 234) –
see "Set Ethernet address of PC" on page
72
"Using parameter sets" on page
"Set Ethernet address of PC" on page
80.
A04643_04_X00_03 HBM: public
104.
78.
78.
ClipX