HBM ClipX Bedienungsanleitung Seite 27

No. Description
5 X5: Fieldbus, here PROFIBUS (only BM40PB)
6 HBM calibration label and free labeling space
Reset button, see
7
work settings (DHCP), enabling fixed IP address" on page 80
Fieldbus LED 1, only BM40IE; EtherCAT, Modbus-TCP: ERR, PROFINET:
8
BF, EtherNet/IP™: NS
Fieldbus LED 2, only BM40IE and BM40PB; EtherCAT, Modbus-TCP: RUN,
9
PROFINET: SF, EtherNet/IP™: MS; PROFIBUS: BUS
10 System LED
X6, X7: 2 x RJ45; P1/IN (X7) and P2/OUT (X6) for EtherNet/IP™, PROF-
11
INET, EtherCAT or Modbus-TCP (only BM40IE)
See also
with screw connections.
Electrical isolation of the GND connections
The following connections are electrically isolated from each other:
• DI, GND (Ground) Digital-In: Reference potential for DI1 and DI2.
• X, GND ClipX bus: Reference potential for ClipX bus (CxA, CxB) and Sync;
on the BM40PB PROFIBUS-GND is also connected by this.
• AI, GND Analog-In: Reference potential for U-In and I-In; the adjacent mea-
surement inputs for voltage and current.
• S GND for the inner shield on double-shielded cable; with 1-Wire TEDS,
TEDS (–) is also connected here.
• AO, GND Analog-Out: Reference potential for the analog output.
ClipX
"User Management" on page
"Electrical connections, LEDs" on page 21
A04643_04_X00_03 HBM: public
Electrical connections, LEDs
82, "Resetting Ethernet net-
for plug terminals
25