The Control Word - HBM ClipX Bedienungsanleitung

Bit Explanation
9 Result for limit value switch 2.
10 Result for limit value switch 3.
11 Result for limit value switch 4.
12 ... 19 Flags 1 to 8 of the calculated channels.
20 ... 29 Not in use.
30 Always 0.
31 Always 1.
32 ... 47 Flags 1 to 16 of the fieldbus.
48 ... 63 Flags 1 to 16 transmitted via Ethernet.
No output, i.e. not assigned. This is useful for unused flags, for example,
64
and is the default setting for calculations.
9.6.5

The control word

Setting a bit in the control word (Set command) triggers the function specified in
the table. However, all set functions are always executed, even if only one bit is
changed. If, for example, bit 1 (Tare) is already set, taring is triggered again on
every change of one of the other bits. The control word comprises 32 bits; the
bits not listed here are reserved for later upgrades.
The control word is acknowledged by ClipX – see
to the controller" on page
control word, the action has been executed and you can delete the bit.
Bit
0 Zero (the gross value).
1 Tare (zero the net value).
2 Clear Zero Value (= 0).
ClipX
129. If the acknowledgment matches the transmitted
Function
A04643_04_X00_03 HBM: public
Operation via fieldbus
I/O status
Low word
I/O status
High word
"Data transfer from the ClipX
163