Assembly And Activation; Connecting The Computer; Computer Activation; Start, Control And Signals - Energetics E-205 Bedienungsanleitung

Assembly and activation

Connecting the computer

Data cable: Connect the data cable coming from the equipment with the
one coming from the computer [1] .
Mounting: Attach the computer to the mount on the equipment . Carefully
slide the insert sleeve on the back of the computer over the mount on the
centre post [2] .
Pay attention not do damage the data cable when sliding the computer
housing over the mount .
Then you fasten the four fixing bolts [3] .
Hand pulse sensors: Plug the hand pulse cable into the connector on the
back of the computer [4] .
Power supply: The computer gets its power supplied through the data cable
of your equipment. Note: the equipment has to be plugged in and turned
on .

Computer activation

The computer can be activated by pressing any key or when the user starts
to pedal .
1 2 3 3

Start, control and signals

DISTANCE KM TIME
KM/H WATT
PULSE
DISTANCE KM TIME
KM/H WATT
PULSE

Sleep mode

Should the E-205 not receive a signal for more than 4 minutes it changes into
the sleep mode . The display turns dark . To start again press any key or start
to pedal .
!
If the computer does not receive a signal
for more then 4 minutes the sleep mode is
activated.
4
The computer starts with a short
beep when in the quick start mode .
CAL
This is displayed briefly in the orien-
tation line .
After a couple of seconds the display
changes to START PEDALING . You
CAL
can now start your work out or select
a special function .
EN