Energetics E-205 Bedienungsanleitung Seite 30

User Manual
Service
Troubleshooting
Error message
E: The computer receives no signal during the Recovery Program.
ERR: The computer receives no signal in the BMI-BMR-Fat Program test
mode .
ERR2: There is no connection between power board and computer or the
power board is defective .
Solution: see . "The computer display is not working" .
The computer display is not working
• The computer might not be getting power. Check all connections and
cables .
• If all connections are in order and you still have no read out on the display
please contact your local ENERGETICS-dealer .
Heart rate (PULSE) is incorrect or not displayed at all
Monitoring via the hand pulse sensor:
• Check if your hands have proper contact with the sensors. Both hands have
to be placed on the sensors simultaneously . There might be a slight delay
before the read out appears .
• Check all cable connections.
• Try moistening your hands slightly if they are very dry.
Monitoring via the chest strap (optional):
• Not all available chest straps are compatible with the E-205. Check if your
chest strap runs on a frequency of between 5,4 – 5,7 Hz .
• The battery of the chest strap is too weak and needs replacing.
The computer has shut down
In rare cases the computer might shut down, mainly because of sudden
changes in the electrical current or static discharge . Normally the E-205
restarts on its own .
Should this not occur restart the computer by pulling the power plug, wait a
few seconds then reinsert it .
Care
Take care that to avoid any moisture penetration . Clean the computer with a
lightly dampened cloth . Do not use abrasive cleaning solutions .
Maintenance
There is no need for special maintenance . Regularly check that all bolts and
connections have a tight fit . Exchange any defective parts immediately . For
assistance contact your local ENERGETICS-dealer .