Ausführliche Beschreibung
2.3 Achs-/Spindeltausch
5: Ein anderer Kanal hat das Interpolationsrecht, die Achse ist für das NC–Programm
angefordert.
6: Ein anderer Kanal hat das Interpolationsrecht, die Achse ist als neutrale Achse
angefordert.
7: Achse ist PLC Achse oder als Kommandoachse/Pendelachse aktiv, die Achse ist
für das NC–Programm angefordert.
8: Achse ist PLC Achse oder als Kommandoachse/Pendelachse aktiv, die Achse ist
als neutrale Achse angefordert.
9: Fest zugeordnete PLC Achse, im Zustand neutrale Achse.
10: Fest zugeordnete PLC Achse von der PLC kontrolliert, im Zustand neutrale Achse.
Die fest zugeordnete PLC Achse
im Zustand neutrale Achse $AA_AXCHANGE_TYP = 9 und
von der PLC kontrolliert, im Zustand neutrale Achse $AA_AXCHANGE_TYP = 10
wird unabhängig von GET und RELEASE fest dem PLC zugeordnet.
Ob die Achse auch getauscht werden kann, wird über die Systemvariable
$AA_AXCHANGE_STAT[Achse] angezeigt.
2-30
Erweiterungsfunktionen: BAGs, Kanäle, Achstausch (K5)
Funktionshandbuch, 11/2006, 6FC5397-1BP10-2AA0