Setting Up The Quantumx System In Canape - HBM QuantumX Serie Bedienungsanleitung

QuantumX driver for CANape
4

Setting up the QuantumX system in CANape

You must set up the devices used once for each project in CANape. The
QuantumX modules used are specified here and the driver for CANape
integrated. The HBM driver for CANape is then loaded again when this project
is opened. The configuration of the device is independent of this and is
described in Section 5, Page 15.
1. Start CANape and create a new project.
2. Then select Device -> New.
Fig. 4.1: Creating a new device
3. In the next dialog, enter a device name and - if required - a comment for
the device. The device name is subsequently displayed in CANape in the
"Devices" section of the device configuration.
Fig. 4.2: Enter device name
A3325-1.0 en/de
11
HBM