Module Not Found - HBM espressoDAQ DQ401 Bedienungsanleitung

67
Troubleshooting

11.1.1 Module not found

Check whether LEDs on espressoDAQ are lit.
If LEDs are not lit or are only glowing weakly,
 either the USB cable is not correctly inserted or
 the USB connection is either not providing any power or is not providing
sufficient power
The latter can occur particularly when there are several modules connected,
or if more devices are additionally connected via the USB, that also have to
be supplied with power (e.g. hard disk).
In this case, use an active USB hub ( from page 25).
Has the USB driver for espressoDAQ been installed by a PC user with Admi-
nistrator rights?

If necessary, repeat catman Starter installation, as this will pre-install the dri-
ver.
Then, with Administrator rights, connect an espressoDAQ, to complete the dri-
ver installation.
A2888−1.1 en/de