Parameter Sets - HBM CMD Serie Bedienungsanleitung

Device description
40
Tip
More detailed information about TEDS can be found in
the TEDS operating manuals at http://www.hbm.com/
HBMdoc.

7.17 Parameter sets

Two power failsafe parameter sets are stored in the CMD
(flash).
Parameter sets can be selected via
S the CMD Assistant,
S digital input 1,
S an interface command (see the "CMD Command Set"
operating manual).
The changeover time for changing the parameter set is:
S 5 ms without range selection
S 160 ms with measuring range selection
If the internal measuring range of 6000 pC is exceeded,
a reset is performed automatically.
A2781-3.1 HBM: public
CMD