Mounting - HBM PACEline CMD600 Bedienungsanleitung

26
5

Mounting

The charge amplifier can be mounted with two M4 screws.
The signal inputs and outputs are electrically isolated from the housing and
the CMD. So no isolating elements are necessary.
NOTE
The charge amplifier can be mounted in any position.
Only connect the sensors to the amplifier after they have been mounted on
the machine. Sensors can output high charges during mounting, damaging
the amplifier. Seal unused connections with the supplied protective caps.
Dimensions (drilling jig)
Scale: 1:1
Length of M4 screws: min. 16 mm
105
CMD600
A2781−2.1 en/de/fr