Sensor
Example:
CFT piezoelectric force transducer
CMD
7.8
Voltage supply, control inputs and
analog outputs
The 8‐pin M12 device plug (SYSTEM socket) connects
the supply voltage, analog output signal, SensorTeach,
RESET/MEASURE signal and TEDS with the following
processing devices (for pin assignment, see Section
8.2.2, page 45).
Transducer connection
cable for the charge
amplifier
1-KAB143-3
BNC to UNF 1-CON-P3001
sensor adapter
Fig. 7.4
Measuring chain with sensor, cable and CMD
(example)
Only high‐insulation connection cables generating little
triboelectricity (such as 1-KAB143, see accessories) may
be used for piezoelectric sensors.
The CMD charge amplifier is designed for DC voltage
operation (18 ... 30 V). The circuit is intended for opera
tion with separated extra‐low voltage (SELV circuit).
A2781-3.1 HBM: public
Device description
Supply voltage
29