Status Led - HBM CMD Serie Bedienungsanleitung

LED display
green, constant
red, constant
red/green or red/
blue, flashing
CMD
RESET/MEASURE
The RESET/MEASURE input can be used to trigger
measurement, or to clear (RESET) the charge amplifier
input capacitors (see Section 14.3).
SensorTeach
SensorTeach is an additional function for automatically
scaling the charge amplifier (see Section 7.6).
7.2

Status LED

The status LED on the front of the CMD indicates the
current operating status of the charge amplifier.
Information
If not connected to the PC, the flashing LED displays are
backed by the green light of the LED.
As soon as there is a connection to the PC, e.g. with the
CMD Assistant, the flashing LED displays are backed by
the blue light of the LED.
CMD status
Measurement
Reset
Overload
A2781-3.1 HBM: public
Device description
Explanation
The charge amplifier is ready to
measure, but not connected via
the interface.
The charge amplifier is in RESET
mode (not ready to measure).
Overload error (output voltage
more than 10 V). A charge
greater than the measuring range
set on the device can cope with
is output by the sensor.
21