Intended Use; Reasonably Foreseeable Misuses - Optimum OPTImill F 80 Betriebsanleitung

1.4

Intended use

WARNING!
In the event of improper use of the CNC-machine
there may be a risk to the staff,

the CNC-machine and other material property of the operating company will be

endangered,
the correct function of the CNC-machine may be affected.

The CNC-machine is designed and manufactured to be used for milling and drilling cold metals
or other non-flammable materials or materials that do not constitute a health hazard by using
commercial milling and drilling tools.
Using this machine it is possible to perform dry processing as well as processing by using cool-

ing lubricants. "Cooling lubricants" on page 290
The limit values of the balances of the tools need to be observed.
fixtures" on page 227
The CNC-machine must only be installed and operated in a dry and well-ventilated place.
The CNC-machine is designed and manufactured to be used in a non-explosive environment.
If the CNC-machine is used in any way other than described above, modified without the
approval of the company Optimum Maschinen Germany GmbH then the CNC-machine is being
used improperly.
We do not take any liability for damages caused by intended use.
We expressly point out that the guarantee or CE conformity will expire due to any constructive
technical or procedural changes which had not been performed by the company Optimum
Maschinen Germany GmbH.
It is also part of intended use that
the limits of performance of the CNC-machine are observed,

the operating manual is observed,

the inspection and maintenance instructions are observed.

WARNING!
Heaviest injuries through improper use.
It is forbidden to make any modifications or alternations to the operation values of the
CNC- machine. They could endanger the staff and cause damage to the CNC-machine.
1.5

Reasonably foreseeable misuses

Any other use as the one determined under the "Intended use" or any use beyond the
described use shall be deemed as not in conformity and is forbidden.
Any other use has to be discussed with the manufacturer.
It is only allowed to process metal, cold and non-inflammable materials with the milling
machine.
In order to avoid misuses it is necessary to read and understand the operating instructions
before the first commissioning.
The operating staff has to be qualified.
Safety
Version 1.1.2 dated 2019-05-07

Translation of the original instructions
OPTIMUM
M A S C H I N E N - G E R M A N Y
"Tools and tool holding
Intended use
F80 | F105
®
GB
Page 211