Optimum OPTImill F 80 Betriebsanleitung Seite 295

Interval Where?
11.3.1 Cleaning and replacing of the polycarbonate windows
WARNING!
The polycarbonate windows are part of the safety device on your CNC machine.
Damaged, scratched or even broken polycarbonate windows must be replaced
immediately.
A soft cloth should be used to clean the machine safety glass. Have been tested and approved
by us:
Hahnerol glass cleaner (Hahnerol), Sidolin Streak Free (Henkel), Active Window Cleaner (Neu-
mann).
We recommend to replace the polycarbonate windows of the door after 60 months of commis-
sioning of the CNC machine.
In the following cases, an immediate replacement is strongly recommended:
plastic deformation (distortion) by previous impact stress,

cracks,

Damage to the edge seal,

immersion of cooling agent in the composite structure,

destroyed or damaged window (coating) on the workspace or operator position.

Maintenance
Version 1.1.2 dated 2019-05-07
What? How?
The service life off
the interlock switch
on the sliding door
By the service technicians
may have been

reached due to the
297
operating condi-
tions. Replace-
ment is required.
The service life off
the interlock
switches on the
side doors may
By the service technicians
have been reached
due to the operat-

ing conditions.
297
Replacement is
recommended to
ensure further,
fault-free operation.
Translation of the original instructions
OPTIMUM
M A S C H I N E N - G E R M A N Y
"Customer service technician" on page
"Customer service technician" on page
®
Check

F80 | F105 GB
Page 295