Optimum OPTImill F 80 Betriebsanleitung Seite 333

Brief instruction 808D Milling
Basic Theory
Drilling
holes
The easiest method to drill
holes is with CYCLE81/82:
Without/with delay at current
hole depth
CYCLE83:Each drilling
operation needs a withdrawal
distance during deep hole
drilling.
The cycle can be found and
parameterized with the "Drill."
SK.
Drill.
The relevant cycle can now
be found using the vertical
SKs on the right.
Deep hole
drilling
Select "Deep hole drilling"
using the vertical SKs and
parameterize the cycle
according to requirements.
808D
Create Part Program Part 2
Edit Cont. Mill.
Drill. Active
Retract plane, absolute
With the "OK" SK, the values and cycle
call will be transferred to the part
program as shown below.
This will drill a hole at the current
position.
With the "Modal call" SK, holes will be
Drilling
drilled at subsequently programmed
centering
positions until cancelled with the
Center
drilling
MCALL command in the part program.
Deep hole
drilling
The information is transferred as shown
Boring
below.
Thread
Hole
pattern
Deselect
modal
Re-
Sim.
comp-
N325 MCALL CYCLE83( 50.00000, -3.00000, 1.00000, ,9.24000, ,5.00000,
90.00000, 0.70000, 0.50000, 1.00000, 0, 0, 5.00000, 1.40000, 0.60000, 1.60000)
Modal
N330 X20 Y20 ; Hole will be drilled
call
N335 X40 Y40 ; Hole will be drilled
Cancel
N340 MCALL
N345 X60 Y60 ; Hole will not be drilled
OK
Page 333
OPTIMUM
M A S C H I N E N - G E R M A N Y
Modal
call
Cancel
OK
actual effect
For specific parameter
commands, see the next page
Operating and Programming — Milling