Safety Devices; Lockable Main Switch - Optimum OPTImill F 80 Betriebsanleitung

1.9

Safety devices

Use the CNC-machine only with properly functioning safety devices.
Stop the CNC-machine immediately if there is a failure on the safety device or if it is not func-
tioning for any reason.
It is your responsibility!
If a safety device has been activated or has failed, the CNC-machine must only be used if you
have removed the cause of the failure,

have verified that there is no danger resulting for the staff or objects.

WARNING!
If you bypass, remove or deactivate a safety device in any other way, you are
endangering yourself and other staff working with the CNC-machine. The possible
consequences are
injuries due to tools, workpieces or fragments hereof which are flying off at high

speed,
contact with rotating or moving parts,

a fatal electrocution,

seizing of clothes.

The CNC-machine includes the following safety devices:
a lockable main switch,

One emergency stop push-button on the machine control panel, the milling head and on the

electronic handwheel,
A locked, separating protective equipment around the CNC-milling machine with sight win-

dows made of break-proof Makrolon.
Locking switch on the separating safety devices.

1.9.1

Lockable main switch

In the position " 0 " the lockable main switch can be secured against accidental or non-author-
ized switching-on by means of a padlock.
When the main switch is switched-off, the current supply is interrupted.
Except for the areas marked by the pictogram in the margin. In these areas there might be volt-
age, even if the main switch is switched-off.
Img.1-1: Main switch
WARNING!
Dangerous voltage even if the main switch is switched-off.
In the areas marked by pictogram in the margin, there might be voltage, even if the main switch
is switched-off.
Safety
Version 1.1.2 dated 2019-05-07 Translation of the original instructions
OPTIMUM
M A S C H I N E N - G E R M A N Y
F80 | F105
®
GB
Page 215