Optimum OPTImill F 80 Betriebsanleitung Seite 216

OPTIMUM
M A S C H I N E N - G E R M A N Y
1.9.2 Emergency stop push button
ATTENTION!
The emergency stop push button immediately stops the operation of the CNC-machine.
Press the emergency stop push button only if there is a risk! If this push button is
actuated in order to switch off the CNC-machine in the standard operation the tool or
workpiece might get damaged.
After having actuated the emergency stop, turn the knob of the particular push button to the
right in order to restart the machine.
Img.1-2: Emergency-stop push button
1.9.3 Control technical protection
WARNING!
If you bypass a controller you endanger yourself and other persons working on the CNC-
machine.
injuries due to tools, workpieces or fragments hereof which are flying off at high

speed,
contact with rotating parts,

a fatal electrocution,

seizing of clothes.

If you bypass a controller in exceptional cases (e.g. during electrical repairs) short term you
must continuously monitor the CNC-machine during this time.
GB F80 | F105
Page 216
®
Translation of the original instructions
Safety
Version 1.1.2 dated 2019-05-07