Optimum OPTImill F 80 Betriebsanleitung Seite 313

Brief instruction 808D Milling
SEQUENCE
The tool are usually loaded manually into the spindle.
The tool will be automatically loaded into the spindle with an automatic tool changer.
Move
machine with
handwheel
A handwheel can control the axis motion instead of the "JOG" button.
Press the "Machine" key on the PPU
Press the "Handwheel" key on the MCP
Select the axis you want to move with the
appropriate keys. on the MCP
808D
Make sure there is no obstruction when moving
the tool to avoid a crash.
Under "WCS" or
"MCS" state, a handwheel will be shown beside
the axis symbols, showing the axis is chosen,
and can be controlled with a handwheel.
Tool Setup
Select the required override increment
according to the buttons on the right(this
The handwheel increment is "0.001 mm"
The handwheel increment is "0.010 mm"
The handwheel increment is "0.100 mm"
The selected axis can now be moved with the handwheel.
Press "JOG" on MCP to end the function of
Notes: If set the MD14512[16]=80, the system will deactivate the function of
MCP for selecting the axis of handwheel, the user will have to activate
"Handwheel" function with PPU softkey.
Page 313
OPTIMUM
M A S C H I N E N - G E R M A N Y
selection fits all axes)
"Handwheel".
Handwheel
Select the required axis on
Axis Number
the right of the PPU; the
selected axis is shown with a
√
Operating and Programming — Milling
Handwheel