Optimum OPTImill F 80 Betriebsanleitung Seite 372

Brief instruction 808D Milling
SEQUENCE
Machine
coordinate
Calculator
system
You can use the calculator to calculate contour elements, values in the program
editor, tool offsets and workpiece offsets and enter the results on the screen.
Press the "=" SK on the PPU.
808D
Additional Information Part 2
Page 372
Press this SK to delete the contents in the calculator.
Press this SK to exit the calculator screen.
Use this SK to accept the input and write the values to the required
position.
If the input field is already occupied by a value, the calculator will take this
value into the input line.
Use the "Accept" SK to enter the result in the input field at the current
cursor position of the part program editor. The calculator will then close
automatically.
Operating and Programming — Milling
OPTIMUM
M A S C H I N E N - G E R M A N Y