Problem Solving - Optimum OPTImill F 80 Betriebsanleitung

8.1 Problem- solving
8.1.1 Tool changer problem
CAUTION!
The milling spindle must be located above the tool changer, otherwise the machine will
damage the machine as described below.
Cause:
The tool changer can not be moved in the reference mode with the user-defined keys <K9> and
<K10> although the milling spindle is located above the tool changer.
Solution:

Move the milling spindle (milling head) upwards, above the tool changer.

Operate the pneumatic valve of the tool changer manually by means of the red pushbut-
tons.
Img.8-1: pneumatic valve - tool changer
Version 1.1.2 dated 2019-05-07 Translation of the original instructions
OPTIMUM
M A S C H I N E N - G E R M A N Y
F80 | F105
®
GB
Page 287