Personnel Protective Equipment; Safety During Operation - Optimum OPTImill F 80 Betriebsanleitung

OPTIMUM
M A S C H I N E N - G E R M A N Y
Functional test
Equipment
Emergency stop
push button
Switch cabinet cooling
Separating protective
equipment around the
CNC-machine
Date:
1.11

Personnel protective equipment

For some works you need personnel protective equipment as protective equipment.
Protect your face and eyes. Wear a safety helmet with facial protection when performing works
where your face and eyes are exposed to hazards.
Use protective gloves when handling pieces or tools with sharp edges.
Use safety shoes when you assemble, disassemble or transport heavy components.
Use ear protection if the noise level (emission) in the workplace exceeds 80 dB (A).
Before starting work make sure that the prescribed personnel protective equipment is available
at the working place.
CAUTION!
Dirty or contaminated personnel protective equipment can cause diseases. Clean it each
time after use and once a week.
1.12

Safety during operation

WARNING!
Before activating the CNC-machine assure yourself that this will neither endanger other
persons nor cause damage to equipment.
Avoid any unsafe working practices:
The instructions mentioned in these operating instructions have to be strictly observed dur-

ing assembly, operation, maintenance and repair.
Do not work on the CNC-machine, if your concentration is reduced, for example, because

you are taking medication.
Stay on the CNC-machine until the program is termi-

nated.
The running program can be identified by means of
the signal lamp.
- Green light: Program run active
- Yellow light: Disorder
Safely and firmly clamp the workpiece before switching on the CNC-machine.

Never change the dosing of the coolant supply during operation.

Never open the sliding door of the separating protective unit when the CNC-program is run-

ning.
GB F80 | F105
Page 218
®
Check
After actuating an emergency stop push button the CNC-
machine must be switched off.
The cabinet cooling must be running.
If the protective equipment is open it must not be possible to
start program.
Checked by (signature):
Translation of the original instructions
OK
Img.1-3: Signal lamp
Version 1.1.2 dated 2019-05-07
Safety