Optimum OPTImill F 80 Betriebsanleitung Seite 387

Brief instruction 808D Milling
Basic Theory
G87 Boring cycle Ⅰ / reverse boring
cycle Ⅱ
Common programming structures:
G87 X—Y—Z—R—Q—P—F—L
Motion process:
①
Drilling motion (-Z) → cutting feed
②
Motion at the bottom of the hole →
spindle stops
③
Retraction motion (+Z) → manual
operation or fast feed
G87 execution operation graphic:
Fixed cycle Ⅰ
spindle start
Origin
Z point
Using G98
spindle stop
808D
G87 execution operation graphic:
OSS
Fixed cycle II→
spindle start
Positioning of Spindles
OSS
OSS
Tools move
Fast feed
Cutting feed
Manual feed
spindle start
spindle start
R point
Z point
Using G99
spindle stop
ISO Mode
ISO program
transfer and
operation
Transfer ISO files in USB device to 808D.
Step 1
Connect the USB device with the stored target programs to the USB interface on the
PPU.
Z point
Use the "Cursor + Select" keys to select the required
R point
A specified ISO program is then stored in the 808D system and can be edited and
executed as described above.
Make the necessary changes to the ISO programs.
Step 2
Programs in ISO mode in the 808D have their own rules. Suitable
changes must be made at the appropriate positions so that you can run
the ISO programs!
Page 387
OPTIMUM
M A S C H I N E N - G E R M A N Y
The ISO mode function provided by the 808D can
easily operate the existing ISO program!
Press the "USB" SK on the PPU.
program which is then highlighted.
Press the "Copy" SK on the PPU.
Press the "NC" SK on the PPU.
Press the "Paste" SK on the PPU.
Operating and Programming — Milling
+